木棉基活性炭纤维吸附性能的研究

采用浸渍(NH₄)₂HPO₄化学活化法650℃时制备得到3种新型木棉基活性炭纤维，即只浸渍不预氧化方法处理的AK1(activated kapok)，先浸渍后预氧化的AK-2和先预氧化后浸渍的AK-3。利用制备得到的活性炭纤维处理苯酚和亚甲基蓝的模拟废水，AK-2具有苯酚最大吸附量(137.00 mg/g)，AK-1具有亚甲基蓝最大吸附量(274.11 mg/g)。吸附苯酚时，在静态平衡实验中，更符合Freundlich吸附等温线；在动力学实验中，更符合准一级反应。吸附亚甲基蓝时，在静态平衡实验中，AK-1更符合Langmuir模型，AK-2 、AK-3更符合Freundlich吸附等温线；在动力学实验中，更符合准二级反应。     

The Use of Nahcolite Ore and Bag Filters For Sulfur Dioxide Emission Control

This paper describes some technical and economic aspects of the nahcolite ore injection process for the simultaneous removal of fly ash and sulfur oxides from stack gases. The process is capable of removing greater than 99% of the particulate matter and greater than 70% of the sulfur oxides present in such gases. In the process, nahcolite ore, a naturally occurring material containing 70 to 90% sodium bicarbonate, is ground to 90% passing through —200 mesh screens. Approximately 20% of the ground ore is used to precoat the filter bags in a baghouse filter while the remainder of the material is fed into the flue gas Just ahead of the baghouse. The flue gas is drawn through the baghouse by induced draft fans and sent up the stack. Most of the SO₂ and practically all of the fly ash in the flue gas can be removed as the gas passes through the filter bags. The spent nahcolite ore and fly ash are collected and conveyed to waste disposal as landfill, or alternatively processed for insolubilization by coprecipitation prior to landfilling. The technical feasibility of the process has been demonstrated in both bench scale and pilot scale engineering studies. Economic analyses performed for the cases of plants located in the midwest and southwest indicate lower capital costs for the nahcolite injection process when compared to wet scrubbing. On an annual cost basis, the nahcolite ore Injection process is comparable in cost to wet scrubbing for the case of the southwestern power plant, and somewhat more expensive for the case of the midwestern plant.     

The Impact of Air Pollution On Eastern White Pine: The Chlorotic Dwarf Disease

Chlorotic dwarf is a serious disorder of eastern white pine (Pinus strobus L) in young plantations. Diseased trees are stunted and possess only current mottled foliage. Investigations into this problem were to define its symptomatology and etiology and to develop measures for control. Previous work had shown that susceptibility to chlorotic dwarf is genetically controlled and that the disease results from an aerological agent acting directly upon the foliage. By controlling the atmospheres around chlorotic dwarf field trees, evidence was obtained to prove that chlorotic dwarf is effected by the injury of gaseous dispersoids on the foliage of susceptible individuals.     

Organic aerosol characterization by complementary measurements of chemical bonds and molecular fragments

Organic aerosol chemical markers from normalized concentrations of independent measurements of mass fragments (using Aerosol Mass Spectrometry, AMS) are compared to bond-based functional groups (from Fourier Transform Infrared spectroscopy, FTIR) during eight field projects in the western hemisphere. Several field projects show weak correlations between alcohol group fractions and m/z 60 fractions, consistent with the organic hydroxyl groups and the fragmentation of saccharides, but the weakness of the correlations indicate chemical differences among the relationships for ambient aerosols in different regions. Carboxylic acid group fractions and m/z 44 fractions are correlated weakly for three projects, with correlations expected for aerosols dominated by di-acid compounds since their fragmentation is typically dominated by m/z 44. Despite differences for three projects with ratios of m/z 44 to m/z 57 fragments less than 10, five projects showed a linear trend between the project-average m/z 44 to m/z 57 ratio and the ratio of acid and alkane functional groups. While this correlation explains only a fraction of the fragment and bond variability measured, the consistency of this relationship at multiple sites indicates a general agreement with the interpretation of the relative amount of m/z 44 as a carboxylic acid group marker and m/z 57 as an alkane group marker.     

利用污泥进行水体中重金属生物吸附研究现状及展望

对国内外利用废水处理等工业过程中所产生的污泥作为生物吸附剂吸附水体中重金属的研究现状进行了综述和分析，包括其预处理技术、反应机理、主要影响因素、处理效果以及反应器工艺等。同时，对该技术未来的发展趋势进行了展望，指出依托现有废水处理设施进行集约化开发将是该工艺的发展方向。     

Acute toxicity and ecotoxicological risk assessment of rice pesticides to Lithobates catesbeianus tadpoles

The objective of this study was to determine the acute toxicity of some pesticides used in irrigated rice farming to Lithobates catesbeianus tadpoles. The LC_50-96h for commercial formulations containing bentazon, penoxsulam, vegetable oil, permethrin and carbofuran, separately and their mixtures, were determined at the proportions commonly used in the field. The limits of risk concentrations of these products for the studied species were also established. The LC_50-96h for tadpoles was 4,530 mg L^?1 for bentazon; 7.52 mg L^?1 for penoxsulam + 145.66 mg L^?1 of vegetable oil; 81.57 mg L^?1 for vegetable oil; 0.10 mg L^?1 for permethrin; 29.90 mg L^?1 for carbofuran (active ingredients), and 38.79 times the dose used in the field for the mixture of these products. The environmental risk was determined only for permethrin, and care should be taken when using the vegetable oil.     

The Properties of Poly(<Emphasis Type="SmallCaps">l</Emphasis>-Lactide) Prepared by Different Synthesis Procedure

Different synthesis methods were applied to determine optimal conditions for polymerization of (3S)-cis-3,6-dimethyl-1,4-dioxane-2,5-dione (l-lactide), in order to obtain poly(l-lactide) (PLLA). Bulk polymerizations (in vacuum sealed vessel, high pressure reactor and in microwave field) were performed with tin(II) 2-ethylhexanoate as the initiator. Synthesis in the vacuum sealed vessel was carried out at the temperature of 150 °C. To reduce the reaction time second polymerization process was carried out in the high pressure reactor at 100 °C and at the pressure of 138 kPa. The third type of rapid synthesis was done in the microwave reactor at 100 °C, using frequency of 2.45 GHz and power of 150 W at the temperature of 100 °C. The temperature in this method was controlled via infrared system for in-bulk measuring. The solution polymerization (with trifluoromethanesulfonic acid as initiator) was possible even at the temperature of 40 °C, yielding PLLA with narrow molecular weight distribution in a very short period of time (less than 6 h). The obtained polymers had the number-average molecular weights ranging from 43,000 to 178,000 g mol⁻¹ (polydispersity index ranging from 1 to 3) according to the gel permeation chromatography measurements. The polymer structure was characterized by Fourier transform infrared and NMR spectroscopy. Thermal properties of the obtained polymers were investigated using thermogravimetry and differential scanning calorimetry.     

Partitioning of perfluorooctanoate (PFOA), perfluorooctane sulfonate (PFOS) and perfluorooctane sulfonamide (PFOSA) between water and sediment

Laboratory partitioning experiments were conducted to elucidate the sorption behaviour and partitioning of perfluoroalkyl compounds (PFCs). Three different sediment types were used and separately spiked with perfluorooctanoate (PFOA), perfluorooctane sulfonate (PFOS) and perfluorooctane sulfonamide (PFOSA) at low environmentally realistic concentrations. PFOA, PFOS and PFOSA were mainly distributed in the dissolved phase at low suspended solid concentrations, indicating their long-range transport potential in the marine environment. In all cases, the equilibrium isotherms were linear and the organic carbon normalised partition coefficients (K_OC) decreased in the following order: PFOSA (log K_OC = 4.1 ± 0.35 cm³ g⁻¹) > PFOS (3.7 ± 0.56 cm³ g⁻¹) > PFOA (2.4 ± 0.12 cm³ g⁻¹). The level of organic content had a significant influence on the partitioning. For the sediment with negligible organic content the density of the sediment became the most important factor influencing the partitioning. Ultimately, data on the partitioning of PFCs between aqueous media and suspended solids are essential for modelling their transport and environmental fate.     

Influence of constant and fluctuating temperature on biodegradation rates of fish biodiesel blends contaminating Alaskan sand

Bioremediation of sandy soil contaminated with fish-biodiesel, conventional diesel, and blends of both was studied in microcosm experiments at different temperatures, simulating the subarctic environment. While distinct lag, exponential, and stationary phases were observed at 20 °C, degradation at 6 °C was slow and the lag phase continued throughout the 4-week experiment. A three-phase 1st order kinetic model successfully described respiration at 20 °C, a one-phase model was sufficient at 6 °C. For temperatures fluctuating between ∼6 and ∼20 °C, higher than expected microbial activity persisted at 6 °C for several days, due to the presence of active cultures, even though the soil temperature closely followed the air temperature. At 20 °C, respiration peaked already after 1 week, and 18-51% of the initially added fuel was mineralized within 4 weeks, whereby degradation was higher at higher biodiesel percentages. Biodiesel addition accelerated mineralization of blends with regular diesel beyond expectations. In blends with 20% biodiesel, the degradation rate constant was twice as high as for conventional diesel. These synergistic effects are likely due to an active microbial population. Addition of biodiesel to conventional diesel could reduce the impact of diesel spills.     

净化SO2的生物膜填料塔中微生物类群分析

对净化废气中SO2的生物膜填料塔内的微生物进行了分离纯化并做鉴定,得到一株嗜酸性氧化硫硫杆菌（Acidithiobacillus thiooxidans IEL001）和一株分类地位非常接近链二孢属（Bispora sp.）的极端嗜酸真菌IEL002,生物膜填料塔内的极端酸性环境和有机营养的缺乏导致生物膜上的微生物种类较为单一,多样性程度不高。本研究还发现IEL002自身并不能氧化单质硫,但它能促进Acidithiobacillus thiooxidans IEL001对单质硫的氧化。